If the bearing is not installed correctly, not only will the bearing not work properly, but it will also cause great damage to each meshing surface. Because the difference between the sleeve ring and the sleeve ring is not very large, special attention should be paid during installation, and they should not be installed together.

When installed correctly, it should be able to adjust the rotation of the rolling body by itself, and the stainless steel bearing manufacturer needs to ensure that the rolling object is in the upper and lower raceways. In addition, there should be a gap of 0.2~0.5 mm between the bearing race and the bearing seat hole to compensate for the error caused by inaccurate processing or installation. When the center position of the bearing sleeve deviates during operation, it can ensure its adjustment, prevent collision and friction, and ensure its normal operation. Otherwise, it will cause bearing damage.

Issues to pay attention to during installation

For bearings with clearance, a very thin layer of anti-creep corrosion liquid should be added to the mating surface to avoid friction corrosion.

During installation, the force on the bearing should not be transferred from one support to another in the same way as the rolling element, otherwise it will cause damage to the raceway. However, in any case, the bearing ring, cage, rolling element or seal cannot be directly hit.

Install the eccentric shield. First, put the eccentric sleeve on the eccentric step of the inner sleeve of the bearing, then turn it axially with both hands, then insert or press the small iron rod into the groove on the eccentric sleeve, and then use a hammer to knock along the axis until the eccentric sleeve is fixed, and finally tighten the hexagon socket screw.

First, do not tighten the bolts that fix the support, so that the bearing sleeve rotates on the support. Then fix the screws of the bearing seat. Similarly, install a support on the same shaft, turn the shaft twice to align it.

Match the grease with the bearing seat, and place the bearing in the bearing seat. Then install the installed bearing and support onto the shaft and push it into the required position.